Mining 102 miner's lamp charging shelf, miner charger, the miner charging cabinet lithium miner 
 First, the performance and structure 
 KTSB (W) series automatic voltage regulator charging rack for miner's lamp battery DC power for charging. Constant voltage parallel connection charging method, charging simplicity. Final the miner battery charging, the charging current below 0.1 amperes, will not overcharge. If the miner's lamp battery is not in use, can be less than the frame. 
 Each discharge in varying degrees miner battery can be added to our catalog on charge without disturbing each other. 
 KTSB (W) automatic voltage regulator charging rack, including two major charging rack and silicon rectifier, the rectifier part of the installation in the charging rack at the bottom of. 
 Second, the conditions of use 
 This charging rack installed in the lamp room with the following conditions: 
 1, the ambient temperature does not exceed 40 ℃, not lower than -30 ℃. 
 2, an altitude of over 2000 meters. 
 3, the air relative humidity less than 85%. 
 4, light room located at the surface and no severe vibration and shock. 
 5, the indoor air circulation, non-conductive dust. 
 6, no water or other liquid immersion. 
 Three charging circuit, charging rack 
 Charging Stand is divided into three levels, on both sides on each side on each floor can put a miner's lamp battery 17, each charging circuit Charging indicator to indicate the charging current, if the miner's lamp battery energy can also be charged. 

 Four silicon rectifier electrical schematic 
 How it works: When the grid voltage fluctuations or load fluctuations caused by fluctuations in the output rectifier voltage, by changing the reactance of the saturable reactor change to achieve the purpose of voltage stability. As the miner charging current is a change in grid voltage is also a variation of these two quantities changing miner charging voltage at the same time to make the appropriate changes, affecting the quality of miner charge. Change after joining the regulator device removed from the output a, b, precise comparison with the amount of controller internal standard change by c outputs an automatic adjustment, zoom and automatic control changes in the DC excitation current , so that the output voltage remains within the range of 5 ± 1% of setting value, to achieve the purpose of the automatic voltage regulator. 

 Instructions and charging Note 
 The intelligent charging rack Division I independent production of smart table, a red light when charging, full for the green light. 
 A miner's lamp charging rack installation, the first ground screw in to the airfield, five centimeters higher than the general floor surface. 
 2, connected to the AC power indicator light, the DC voltmeter indicates the voltage load. 
 3, the hairs of the miner's lamp battery charging stand number sit in seat, turn off the lamp switch to lamp charging plug on the charger plug into the charging rack, clockwise rotation of 180 °, until a fixed position, the circuit connected. If the charge indicator direction, the normal charge. 
 In the manual charging every one hour to adjust voltage, the charge current is: 
 The beginning of rechargeable batteries, 1 amp charge for 72 hours; 
 The daily charge batteries for 2 Amps continuous charge of 2 hours; 
 When charging is completed, the charging current should be less than 0.1 amps. 
 5, in charging the individual charging indicator pointer does not move too much difference, should be checked throughout the exposure. 
 6, in the process of charging, such as the external power supply is suddenly opened, should be immediately to the counterclockwise rotation of each light the lamp, promptly disconnect the charging circuit. 
 7, the charging rack part should be kept clean and dry. 
 8, charging stand, such as leak electrolyte, must be immediately removed to avoid corrosion of the machine. 
 9, silicon rectifier should be more frequent cleaning to keep clean.